- how many fixing kits should be purchased for each dinamika hinge?
- The fixing kits for cold cut profiles should be purchased in a 1:1 ratio. While for fixing kits for thermal cut profiles should be purchased in the following way: 2 kits for every 2 hinges with 3 wings and 3 kits for every hinge with 3 wings
- what is the difference between the new big version C and version D
- The C version is made of die-cast aluminium, so it cannot be oxidized. The D version is made entirely in extruded aluminium and, therefore, is available in oxidized versions as well.
- Can I have the dinamika with oxidized finish?
- Yes, because the special wings and the sheet are made of extruded aluminum
- how can I adjust the height of the Slim Rapid hinges
- By applying the 8060.20 regulator on the profile, acting on the grub screw in the regulator, you can raise the wing/leaf to the desired position. This operation can be done by a single operator regardless of the weight of the wing/leaf
- which fastening kits to buy in combination with the hinges
- we have counterplate kits for cold-cut series and self-centering pins for thermal-cut systems
- Is it possible to apply dinamika to emergency exit doors and escape routes?
- yes, dinamika has the CE marking necessary for this purpose (see certifications / quality pages of the website)
- how can I determine the number of hinges to buy?
- the technical catalogue and the brochure show the capacity diagrams that allow to to establish the maximum capacity and the number of hinges to buy
- it is possible to have adjustable quick-release hinges
- they are available, art. 9201.3 and 9202.3 adaptable to the various types of European chambers, by rotating the bushing you can adjust the clearance up to + – 0.7mm
- which hinges are recommended for vasistas and protruding opening frames?
- We recommend the use of comb hinges, art. 3420.71 (European Chamber) or 3421.71 (hollow erre)